To emboss the base and bottle label I laser cut more logos out and glued them onto card to emboss the base
This was the first result that we were happy with, this was made by not using any padding and applying a lot of pressure
Aligning the logo to the right place is the biggest problem because you can hardly see where you are placing the stamp
After applying too much pressure our logo got squashed down a bit, we applied some water and padding so that the pressure would be spread evenly and the paper would take the emboss easier.
This worked well but was a bit too deep and also damaged the paper too much
After damaging the first mould quite a lot we laser cut more letters to use for the final products on Monday 11th. We will emboss each 4 of the bases and 4 labels for the bottles
No comments:
Post a Comment